Hydraulic winch 10 kN – F206.10

Hydraulic winch 10 kN – F206.10

Hydraulic, drum cable winch made by OMAC Italy.

Primarily designed to pull one rope for service operations such as alignment and correction of transmission lines and cable line laying.

The standard version of the winch is equipped with:

• One closed hydraulic circuit, therefore it allows you to continuously change the speed in both directions from the control panel.
• Removable drum.
• Automatic idle rotating rope winder for manual operation.
• Dynamometer to read the pulling force.
• Free movement of the drum.
• Negative hydraulic safety brake.
• Rigid axle and drawbar to move the machine at low speed around the job site.
• Stabilizers and attachments for anchoring the machine.
• The oil cooler in the hydraulic circuit.
• Roller guide designed for vertical and horizontal pulling operations.

Capacity of rope:
Ø 8 mm 800 m
Ø 6 mm 500 m

OPTIONAL EQUIPMENT

003 – Axle with independent torsion bar and wheels for towing on the road at 60 km/h, with mechanical parking brake.
026 – PVC protective tarpaulin.
028.2 Cable-start diesel engine.
034 – Diesel engine started from a 12V battery.
035 – Maximum pull force selection switch to stop the motor in case of excessive force.
056.4 Steel service capstan next to the drum.
065 – Automatic rope clamp on the side of the winch.
090 – 220V Single Phase Electric Motor
090.1 Three-phase electric motor

Other winches are available in our online shop.